Application tool: cloth or brush
Location: interior wood surfaces
Dry time: 15 minutes
Stain application: after 15 minutes, but no more than 2 hours
Cleanup: mineral spirits
Coverage: 125-150 sq. ft. per quart
Coats: normally 1, but additional coats may be applied on highly absorbent woods
Recommended uses: any softwoods which tend to absorb a stain unevenly - common examples include pine, fir, spruce, alder and aspen

THE FIRST STEP IN PROFESSIONAL WOOD FINISHING

Many softwoods, particularly pine, have a tendency to absorb stain unevenly. Minwax® Pre-Stain Wood Conditioner is specifically designed for use before staining new or bare softwood surfaces. It penetrates the grain of the wood to promote uniform acceptance of stain. Treating the surface with Minwax® Pre-Stain Wood Conditioner helps prevent streaking and blotching to help ensure a beautiful, even stain. To determine if you are working with softwood, press your fingernail against a hidden section of the wood. If you make a dent, the wood is soft and probably needs conditioning to help avoid an uneven stain color.

DIRECTIONS:

1. Apply before staining on clean, raw wood, using a brush or cloth.
2. Allow to penetrate for 5 to 15 minutes, then remove excess with clean, dry cloth.
3. The stain should be applied within two hours of application of Minwax® Pre-Stain Wood Conditioner. For best results, stain with Minwax® Wood Finish™, Minwax® Polyshades®, or Minwax® Woodsheen®.

Note: For long-lasting protection, complete your project with Minwax® Fast-Drying Polyurethane or Minwax® Polycrylic® Protective Finish.

DANGER: Combustible. Contains mineral spirits. Harmful or fatal if swallowed. Do not take internally. Skin irritant. Avoid contact with skin and eyes. Wear rubber gloves and eye protection. Use with adequate ventilation and avoid inhalation. Open windows and doors, ensure fresh air movement. Keep away from heat, sparks, open flame or other sources of ignition. KEEP OUT OF REACH OF CHILDREN.

FIRST AID:

FOR SKIN CONTACT: Wash thoroughly with soap and water. If irritation persists, get medical attention.

FOR EYE CONTACT: Immediately flush eyes thoroughly with water, then remove any contact lenses. Continue to flush eyes with water for at least 15 minutes. If irritation persists, get medical attention.

IF SWALLOWED: Do not induce vomiting. Call physician immediately. If affected by inhalation, immediately remove to fresh air.

Solvent: Non-photochemically reactive.

Looking For More Information? Windsor Plywood Recommends The Following Links:

Visit The Minwax® Web Site